Lake Level Report – Septic Systems

SEPTIC SYSTEMS

A section from the Lake Level Monitoring report contained in Staff Report from the December 13, 2012 board meeting material.  This section drafted by Seth Lenaerts.

In order to determine the impact of lake level on septic systems, the following areas were considered.

  • Design standards
  • Groundwater levels and movement
  • Soil characteristics
  • Septic attributes

Design Standards Overview

Design standards are subject to change and evolve on an annual basis. The most dramatic one time change was in 1974, when the Onsite Wastewater Management Program was created and the Department of Environmental was charged with running the program. Previously septic systems had been under the jurisdiction of the Health Department.

For the sake of this discussion, current design standards for traditional systems will be referenced. Keep in mind variances are allowed and DEQ will allow such variances depending on certain conditions. In addition, a property owner can use an advanced treatment technology which may also allow them to vary from the design standards for a traditional system.

Design standards were developed in order to protect the land, surface water, groundwater, and public health. Minimum design standards are intended to meet these criteria. Minimum design standards specify many aspects of the system including, depth of septic tank, linear feet of drainfield, drainfield trench depth, soil characteristics, depth to bedrock or hard pan, depth to groundwater, and setbacks from property lines, public water ways, utilities, and wells.

Design standards are developed to ensure that effluent will have gone through a sufficient level of treatment in order to protect public water ways from environmental degradation, and the public from disease.

Oregon Design Standards Impacting Depth to Groundwater

When discussing the impact of increasing lake level, impacts are primarily seen due to the increase in groundwater depth, and increasing soil saturation. In order for an onsite wastewater treatment system to properly treat effluent using a septic tank and a traditional drainfield, it is important that the first five feet (60 inches) of soil does not have any hindrances to treatment. The most concerning in terms of water contamination are high groundwater/saturated soils, or an impediment such as bedrock or a hardpan.

In order to protect public waters the state of Oregon has the following rules regarding the siting of septic systems and the water table.

  • Depth to water table: Permanent water table four feet from the bottom of the trench.
  • Depth to seasonal water table: Bottom of trench can go to the seasonal high water table interface.
  • Trench depth: 18 – 24 inches based on slope.

Groundwater Characteristics

Groundwater information for the Devils Lake watershed was collected from the US Geological Survey (USGS), US Department of Agriculture (USDA), and the Natural Resources Conservation Service (USGS).

The table and map below are based on the USDA & NRCS – Soil Survey and describes the soils in the Devils Lake watershed. The Soil Survey classifies all soils in the Devils Lake watershed as “very limited” as shown in the map. The table breaks down the soils by soil name, and the limiting features which earn that soil the very limited title. The red background signifies insufficient depth to saturated zone and the yellow signifies insufficient depth to bedrock. As discussed later in this report depth to bedrock is important when considering shoreline properties since it is likely that the water table follows the bedrock and land contours. Therefore, it can be expected that in areas limited by depth to bedrock, depth to saturated zone is also probably a problem.

The final note on the table is the corrosion potential for septic tanks. According the USGS Soil Survey, 97% of the soils in the watershed are rated as highly corrosive to both concrete and steel tanks, and 3% are rated as moderately corrosive.LLRpt Fig 1

Groundwater Movement Considerations

As of 2012 there has yet to be a groundwater study done in Lincoln City or the Devils Lake watershed. The best available information comes from the USGS Soil Survey. As the table “Soil Suitability for Septic Systmes” shows, 16% of soils in the watershed are impacted due to depth to saturated zone. In addition 65% of soils are limited due to depth to bedrock. Depth to bedrock in an important consideration since groundwater will tend to follow the topography of the surface and bedrock. Therefore, if water level rises on the lake, hydraulic pressure will build and groundwater levels will increase. The increase in groundwater levels potentially may saturate or increase the failure risk of near shore drainfields.

Additional considerations regarding groundwater movement:

  • Groundwater tends to follow surface topography.
  • During dry seasons, depth to groundwater increases, during wet seasons it decreases.
  • Groundwater will flow from high pressure to low pressure, and can move up or down (downward due to gravity, upwards due to high pressure). DLWID Staff Report 2012-12-13
  • Where the water table intersects the surface, we see streams, or springs.
  • Most pollution of groundwater is the result of biological activity, much of it human, from sewer, septic tanks, waste dumps, agriculture, salt water contamination…

Septic Attributes

LLRpt Fig 2Septic systems are intended to be a rural tool to dispose of sewage in a safe manner. Septic systems are effective when they are, sited, designed, installed, and maintained properly. In order to assure that a system is functioning properly it should be installed in soils that provide an adequate level of treatment, with limited constraints. According to NRCS, all soils in the watershed are constrained and have received the “very limited” designation. NRCS defines ‘very limited” as the following:

“Very limited” indicates that the soil has one or more features that are unfavorable for the specified use. The limitations generally cannot be overcome without major soil reclamation, special design, or expensive installation procedures. Poor performance and high maintenance can be expected.

Soils in the watershed are limited for many reasons including: flooding, ponding, depth to saturated zone, subsidence, slow water movement, too steep, depth to bedrock, depth to cemented pan, and seepage.

For the impacts of lake level discussion, depth to saturated zone, and depth to bedrock, are the most evident, however, increased could also impact other limitations, like slow water movement and seepage.

The map below shows the soil types broken down by limitation, with red signifying the soil is limited due to depth to saturated zone, yellow signifies depth to bedrock, and green signifies the slopes are too steep.

In addition to concerns about soil characteristics, there are many systems that have exceeded their lifespan, or have no public record.

Finally, the density of septic systems around Devils Lake greatly exceeds EPA standards. EPA has said that over 1 system per 16 acres has a high potential

LLRpt Fig 3

of groundwater contamination. A study by the University of Purdue which is backed up by other university studies came to a different conclusion stating that as a general rule of thumb there can be one to two systems per acre before seeing signs of groundwater contamination.

Regardless, lakefront properties greatly exceed both of those standards. Two to three systems per acre is normal, and parts of the shoreline and near shoreline have density rates of three to six systems per acre. Density rates at this level exceed EPA recommendations by as much as 9500% and the one to two per acre standard by 100% – 600%.

Impacts

Does damming Devils Lake and subsequently raising the lake level impact septic systems? The answer to that is definitely, yes. The follow up to that question is, to what extent? That question is much more difficult to quantify.

However, we can confidently state the following:

Septic systems in the Devils Lake watershed are old, lack records, are being used in soils that the NRCS classifies as unsuitable for septic systems and highly corrosive to septic tanks. Raising lake level only increases the inefficiencies of already inadequate soils.

Groundwater follows surface topography and will generally be at the same level as the surface of the lake. Therefore, raising the lake level, decreases depth to groundwater, which decreases the amount of treatment that effluent receives before entering the groundwater.

A failing system that is discharging directly into groundwater will not show obvious symptoms of a failure, such as slow draining, backing up, or pungent odors over the drainfield.

Areas around Devils Lake have septic densities that exceed EPA suggestions by 4,700%, and parts of the watershed exceed those densities by as much as 9500%. Septic densities also exceed the one to two systems per acre shown to prevent impacts to groundwater. Those densities are exceeded in areas by 100% – 300%.

The integrity of the first 60 inches of soil is necessary in order to sufficiently treat effluent. Raising lake level decreases the treatment zone.

Oxygen is required to effectively breakdown effluent; saturating soils on an annual basis will create anoxic conditions not conducive to treating effluent.

Leave a comment

Filed under DLWID, Meeting Reports, Septic

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s